[. . . ] Set the front bezel aside. 15G067224000 Screwless Model Copyright © 2005 ASUSTeK COMPUTER INC. [. . . ] All Rights Reserved. Installing the power supply unit (PSU) 1 2 Installing an optical disk drive (ODD) 1 2 Installing a hard disk drive (HDD) 1 2 Push the bay lock upward. Slide the PSU into the slot until it snugly fits the metal rail. Insert the ODD into the bay. 3 1. Align the HDD holes with the bay holes, then push down the bay lock to secure the HDD. 3 Secure with screws. Align the ODD holes with the bay holes, then push down the bay lock to secure the ODD. Release the lock tabs on the front bezel to disengage the drive cover. Installing a floppy disk drive (FDD) 1 2 Installing an expansion card 1 2 Reinstalling the side cover and front bezel Hook the hinge-like tabs to the holes on the chassis. Swing the front bezel in the direction of the arrow and push to secure the front bezel to the chassis. 1 Using a screwdriver, push the knock-down metal cover in and out of the chassis until it is removed. 3 Insert the FDD into the bay. Make sure the FDD holes align with the chassis holes. 4 Remove the screws securing the bracket to the chassis. Remove the expansion slot bracket. 3 Choose the slot you want to use. Remove the metal cover on the rear panel. 4 2 3 Secure the FDD with screws. Release the lock tabs on the front bezel to disengage the drive cover. Align the card connector with the slot, then press firmly until the card is completely seated on the slot. Replace the expansion slot bracket and secure it with the screws you removed earlier. Push the side cover towards the front bezel. Drive screws on the rear panel. TA/TM 5 Series [. . . ] Remove the metal cover on the rear panel. 4 2 3 Secure the FDD with screws. Release the lock tabs on the front bezel to disengage the drive cover. [. . . ]